DIY Copper Light Switch | Kin Community

SCROLL FOR INSTRUCTIONS + SHOPPABLE LINKS (These links go to Amazon where we are an affiliate partner). DON'T FORGET to LIKE this episode + SUBSCRIBE: http://bit.ly/BlogSubs
***********************************************************
Copper Sheet Metal http://amzn.to/2avFman
X-Acto Knife http://amzn.to/2ayOV65
Bonding Glue http://amzn.to/2aAZJO2
Cutting Mat: http://amzn.to/2avsKdj
***********************************************************
VISIT THE KIN BLOG: http://www.kincommunity.com/
LIKE US ON FACEBOOK: @Facebook
FOLLOW US ON PINTEREST: @kincommunity
FOLLOW US ON TWITTER: @Twitter
ADD US ON SNAPCHAT: kincommunity
************************************************************
Copper Light Switch Directions

__SUPPLIES__
copper sheet
basic light switch cover
ruler/tape measure
pen
box cutter
flat head screwdriver
bonding glue

__DIRECTIONS__
1. Measure light switch cover and round the number up by a couple of centimeters on each side.
2. Using a pen, outline the measurements onto the copper sheet.
3. Using protective gloves, cut out the rectangle with a box knife or equivalent. This might take a few times to cut all the way through.
4. Mark the inside rectangle of the light switch cover onto the copper cutout.
5. Repeat step 3. Have patience! The copper is thick and takes some work, but once you’re done cutting, you have your cover!
6. Using a flat head screwdriver, screw the light switch cover back into the wall.
7. Apply a generous amount of bonding glue to the back of the copper sheet cut out, leaving a ½ inch parameter around the copper cut out unglued.
8. Attach cut out to the original light switch cover and apply pressure until it holds.
************************************************************
For more info on Claire Zinnecker, visit her website:http://clairezinneckerdesign.com/